MRO Magazine

Pre-engineered crane kit cuts installation time

Demag pre-engineered single-girder crane kits are available in either top-running or under-running configurations that allow installers to do their own on-site assembly. The kits are shipped complete ...


June 1, 2010
By MRO Magazine

Demag pre-engineered single-girder crane kits are available in either top-running or under-running configurations that allow installers to do their own on-site assembly. The kits are shipped complete with all necessary components except the steel beams, which can be purchased locally to save freight cost. Crane components include a wire rope hoist, end trucks, bridge panel, festoon system with brackets and a pushbutton station. Typically assembled in less than 21 hours, all kits are plug and play, and no electrical work is required. These kits are designed for builders of beam girder cranes in the 3-ton, 5-ton and 10-ton capacity range.

Demag Cranes & Components

Reader Service Card No. 364

Advertisement

Print this page




Leave a Reply

Your email address will not be published. Required fields are marked *

*