MRO Magazine

News

Bottlemaker in Brampton fined after worker suffers permanent injury


Brampton, ON – A bottle-manufacturing company has pleaded guilty and has been fined $100,000 after a worker suffered a permanent injury in Brampton.

The company, O-I Canada Corporation, has a principal place of business in Ontario at 777 Kipling Avenue in Toronto and operates a glass manufacturing facility located at 100 West Drive, Brampton.

On February 27, 2016, a worker was working at the industrial site in the bottle forming department with a second worker, a machine operator. They were working on a machine known as the Individual Section (IS) bottle making machine.

An IS machine is made up of individual but identical sections placed side by side; each section can be started or stopped independently of the others. This machine is capable of producing 100 bottles per minute by forming molten “gobs” of glass at 1,200 degrees Celsius.

The worker and the machine operator were jointly performing a standard operating procedure which included inspecting bottles and changing all neck rings and plungers. Toward the completion of the task, the worker was removing rings from the front of the machine and lost sight of one of the rings.

The worker asked the machine operator, who was working at the back of the machine, to close the mold. With the mold closed, the worker could reach in and retrieve the ring. While the worker was reaching in, the mold moved from the closed position to the open position. When the mold opened, this pinched the worker’s hand between the mold and a shaft for a few minutes, until a co-worker used a switch to close the mold again. When the mold closed, the worker was able to remove the hand but suffered critical crush and burn injuries that required surgery and resulted in permanent injury.

A Ministry of Labour investigation followed. It was found that the defendant failed to ensure that control switches or other control mechanisms were locked out and failed to ensure that other effective precautions were taken to prevent the starting of mold-opening motion that could endanger a worker.

The defendant failed to ensure compliance with section 76 of the Industrial Establishments Regulation, contrary to section 25(1)(c) of the Occupational Health and Safety Act. Section 76 of the regulation requires that where the starting of a machine, transmission machinery, device or thing may endanger the safety of a worker, control switches or other control mechanisms shall be locked out and other effective precautions necessary to prevent any starting shall be taken.

As such, O-I Canada Corporation failed as an employer to ensure that the measures and procedure prescribed by Ontario’s Industrial Establishments Regulation were carried out at the workplace.

O-I Canada Corporation was fined $100,000 by Justice of the Peace Milagros Eustaquio-Syme in Brampton court on June 13, 2017.

Source: Ontario Ministry of Labour


Rehana Begg

Rehana Begg

Rehana Begg is the editor of Machinery and Equipment MRO magazine and REM – Resource Engineering and Maintenance magazine.
All posts by

Print this page

Related Posts



1 Comment » for Bottlemaker in Brampton fined after worker suffers permanent injury
  1. This accident could have been prevented if the machine was fitted with a Safe-T-Bleed device. Regrettably, manufacturers refuse to use this life and limb saving device because there is no official “safety standard” for this type of safety device.

Have your say:

Your email address will not be published. Required fields are marked *

*